OmniPure K2585-JJ In-line Phosphate Scale Inhibitor

OmniPure In-line Phosphate Scale Inhbiting Filter

1/4" Push Connect Adapters

Part# K2585-JJ

The Omnipure K2585-JJ K-Series 10 1/4 QC Phosphate Scale Inhibitor Inline Filter delivers the best possible combination of meaningful innovation and useful features. Its cap and body are spin-welded together producing a smooth, consistent seal without the use of glues or binders that can cause contamination.

General Installation/Operation/Maintenance Requirement:

• Note flow direction of filter.
• For quick connect fittings, push scratch free tube end into the fitting until it bottoms. Threaded fittings must be wrapped with Teflon tape before installation. Install Teflon taped fittings and tighten firm. Use two wrenches to firmly tighten tubing.
• Flush new cartridge with 5 gallons of water prior to use and check for leaks. If leaks occur, check tightness of tubing and fittings. If leaks persist, discontinue use and call your supporting dealer.
• Replace cartridge when rated capacity (6 months) is reached, or when flow becomes too slow.
• Install in compliance with state and local laws and regulations.

Specifications

• Dimensions – 10”L x 2”Dia
• Flow Rate – Up to 0.50 GPM
• Filter Life - 6 months or 1250 gallons, Maximum Life 1 Year
• Maximum Pressure - 125 PSIG
• Temperature Range35 F to 100 F
• Temperature: 35-100_ F (2-38_ C)
• Connection: 1/4" John Guest (Push Fit) FQC – Plastic or copper
• NSF Tested and Certified

 Notes

• Flow Direction shown on the Filter
• Flush new cartridge with 5 gallons before consumption